Sanding/Finishing - Grizzly G0799 Owner's Manual

4. Loosen headstock, then move it all the way to
tail end of lathe bed, as shown in Figure 51.
Figure 51. Typical outboard turning operation.
(Shown here with Model T27484 Bed Extension
and Tool Rest Riser Bushing.)
5. Retighten headstock to bed.
When outboard turning, ALWAYS use a
floor-mounted tool rest and keep tool in
contact with rest during all turning opera-
tions. Failure to do so could cause tool to be
pulled out of operator's control and ejected
at high speed.
Model G0799 G0800 (Mfd. Since 09/15)

Sanding/Finishing

After the turning operations are complete, the
workpiece can be sanded and finished before
removing it from the lathe, as shown in Figure 52.
Figure 52. Typical sanding operation.
Note: Whenever sanding or finishing, move tool
rest holder out of the way to increase personal
safety and gain adequate working room.
Sandpaper
Wrapping
per completely around
workpiece
your hands into mov-
ing workpiece and may
cause
Never
per or finishing materi-
Workpiece
als completely around
workpiece.
sandpa-
could pull
serious injury.
wrap sandpa-
-41-