Maintenance And Care - Flex TRINOXFLEX BME 14-3 L Manual

– The smaller the pipe diameter, the larger
the possible angle of contact. Up to 270°
are possible.
Sealing the surface:
Many manufacturers recommend sealing
finished surfaces with a protective spray
(see Flex stainless steel accessories).
For further information on the manufac-
turer's products go to www.flex-tools.com.
Switching on and off
Brief operation without engaged switch
Push the switch rocker forwards and hold

in position.
To switch off the power tool, release

the switch rocker.
Continuous operation with engaged switch
Push the switch rocker forwards (1.) and

engage by pressing the front end (2.).
To switch off the power tool, release

the switch rocker by pressing the rear end.
NOTE
Following a power failure, the switched on
power tool does not restart.
24
Preselecting the speed
The adjusting wheel enables the operating
speed to be continuously adapted to the
material requirements.
Speed burnishing
attachment
[r.p.m.]
1 1000
2 1500
3 2000
4 2500
5 3000
6 3500

Maintenance and care

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
WARNING!
If metals are ground or cut over a prolonged
period, conductive dust may become
deposited inside the housing. Impairment of
the protective insulation! Operate the power
tool via a residual-current-operated circuit-
breaker (tripping current 30 mA).
Regularly clean the power tool and ventila-

tion slots. Frequency of cleaning is depen-
dent on the material and duration of use.
Regularly blow out the housing interior and

motor with dry compressed air.
Carbon brushes
The drive unit is fitted with cut-off carbon
brushes. When the cut-off carbon brushes
reach their wear limit, the power tool switches
off automatically.
TRINOXFLEX
Belt speed belt
sander attachment
[m/s]
3,5
4,8
6,1
7,4
8,7
10,0