Instructions For Use - Flex TRINOXFLEX BME 14-3 L Manual

TRINOXFLEX

Instructions for use

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Before switching on the power tool
Unpack the drive unit and attachments,

and check that no parts are missing or
were damaged during transport.
Mounting attachments
Place the required attachment on a level

work surface with the snap coupling facing
upwards.
Open the clamping lever on the

attachment.
Place the drive unit in the required position

to the attachment and press down until it
audibly engages (1.).
Close the clamping lever (2.).

NOTE
The gear teeth in the snap coupling of the
drive unit and the attachment are automati-
cally interlocked when the machine is
switched on.
Removal of attachments
Open the clamping lever on the attach-

ment (1.).
Press and hold down the release lever (2.).

Lift the drive unit off the attachment (3.).

Burnishing attachment BSE 14-3 100
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Mounting the protective cover
CAUTION!
The burnishing attachment may only be
operated after the protective cover has been
mounted.
Open the locking ring for fastening the

cover.
Attach the protective cover (1.).

Close the closing ring for fastening the

cover (2.).
21