Maintenance And Care - Flex WL 300 18.0 Manual

WL 300 18.0
To attach/detach battery pack
(See figure B)
NOTICE: Please refer to the battery pack
and charger manuals for detailed operating
information.
To attach the battery pack:
Align the raised rib on the battery pack with
the grooves in the tool, and then slide the
battery pack onto the tool.
NOTICE: When placing the battery pack
onto the tool, be sure that the raised rib
on the battery pack aligns with the groove
inside the tool and that the latches snap into
place properly. Improper attachment of the
battery pack can cause damage to internal
components.
To detach the battery pack
Depress the battery-release button located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool.
Removable belt clip (See figure C)
Your tool is equipped with a removable belt
clip that can be positioned on the side of the
tool for convenient transport.
Install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib and the hole of the belt clip
with the opening and the threaded hole
on the base of the tool, respectively.
c. Insert the screw and securely tighten the
screw with a screwdriver (not included).
Remove the belt clip from the tool:
a. Remove the battery pack from the tool.
b. Use a screwdriver to loosen the screw
that attaches the belt clip to the impact
wrench.
c. Remove the screw and the belt clip.
Integral hook (See figure D)
Your tool is equipped with a hanging hook. It
can be carried or hung on a hook or a hook-
like object.
To prevent the risk of injury or product
damage, make sure that the hook is sturdy
enough to hold the weight of the light with
attached battery pack.
Adjusting the light head (See
figure E)
The light head pivots 104°for maximum
flexibility. Manually move the head to any
position within the pivot range. Do not force
the head beyond that range.
Switching on and off (See figure F)
Your light is equipped with a two-stage
brightness adjustment, providing different
light intensities for your operation.
Press the ON/OFF switch to turn on the light
in the maximum brightness stage.
Press the ON/OFF switch again to change to
the minimum brightness stage.
Press the third time to turn the light off.
CAUTION!
When the handy LED light flashes and goes
out, it means that the battery voltage is low
and needs to be charged.
Following a power failure, the switched-on
power tool will not start running again.

Maintenance and care

WARNING!
Before performing any work on the power
tool, remove the battery pack from the tool.
Cleaning
■ Clean the power tool and grille in front
of the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
■ Regularly blow out the housing interior and
motor with dry compressed air.
Spare parts and accessories
For other accessories, in particular tools and
handy LED light accessories, can be found in
the manufacturer's catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
11