SRAM GUIDE RSC 2015 Service Manual page 18

Use a torque wrench and a T10 TORX® bit socket to tighten each
4
pivot bolt to 2.7-3.2 N·m (24-28 in-lb).
5 6 Press the bladder into the reservoir cap, make sure the bladder is
properly seated into the reservoir cap. The bladder should be flush
with the cap.
Insert the reservoir cap/bladder assembly onto the lever body.
7
8 Use your fingers to install the detent ball followed by the detent
spring into the lever body reservoir hole closest to the lever blade.
T10 TORX bit 2.7-3.2 N•m (24-28 in-lb)
Lever Blade Installation
22 mm
18