SRAM GUIDE RSC 2015 Service Manual page 15

Place the SwingLink™ onto the SRAM Guide Lever Internals
7
Assembly Tool to adjust the length of the push rod on the
SwingLink.
Use a 2 mm hex wrench to tighten the push rod into the
8
SwingLink.
Use a 2 mm hex wrench to remove the SwingLink from the SRAM
9
Guide Lever Internals Assembly Tool and place the pushrod into
the coupler sleeve.
SRAM Guide Lever Internals Assembly Tool
SRAM Guide Lever Internals Assembly Tool
SRAM Guide Lever Internals Assembly Tool
SRAM Guide Lever Internals Assembly Tool
Piston Assembly Installation
2 mm hex wrench
2 mm hex wrench
2 mm hex wrench
15