SRAM GUIDE RSC 2015 Service Manual page 14

Use your hand to place the sleeve on the coupler.
4
The sleeve threads must be oriented away from the base of the
coupler.
5 Use the SRAM Guide Lever Internals Assembly Tool tool to engage
and thread the sleeve and coupler onto the piston assembly.
Engage the slots on the sleeve with the contact adjust knob and
continue to thread the SRAM Guide Lever Internals Assembly Tool
tool in a clockwise rotation until it stops.
6 Use needle nose pliers to install the SwingLink™ bushings.
If the SwingLink bushings fall out easily, apply a small amount of
grease to the bushings to help hold them in place.
T8 TORX wrench
Guide Lever Internals Assembly Tool
Needle nose pliers
Piston Assembly Installation
20 mm or 15 mm Thru Axle
14
A