SRAM GUIDE RSC 2015 Service Manual page 11

Remove the SwingLink™ bushings by hand.
4
Use a SRAM Guide Lever Internals Assembly Tool to unthread the
5
piston sleeve and coupler. Insert the SRAM Guide Lever Internals
Assembly Tool into the lever body and align the keyslot of the tool
with the piston sleeve. Use the tool to unthread the sleeve and
remove the sleeve and coupler.
If the piston sleeve and coupler are stuck in the lever body use
needle nose pliers to gently remove.
Remove the sleeve from the coupler by hand.
6
Spray isopropyl alcohol on both the sleeve and the coupler and
clean them with a rag.
SRAM Guide Lever Internals Assembly Tool
SRAM Guide Lever Internals Assembly Tool
Piston Assembly Removal 11