Promise Technology VTrak 15110 User Manual page 241

Event
Logical Drive Quick
Initialization Stopped
Logical Drive Percent
Completed
Enclosure Notification
Enclosure Power Down
Enclosure Power Up
Enclosure Unknown Error Unspecified problem with the Controller. If this
Enclosure Over
Temperature
Enclosure Fan Stop
Enclosure 3.3 Volt Range Go to Controller management > Enclosure
Enclosure 5 Volt Range
Enclosure 12 Volt Range
Battery Temperature Rise Click on Enclosure1 in WebPAM to check for
Battery Temperature
Dropped
Battery Capacity below
threshold
Battery Capacity Normal
Battery Discharging
Battery Maintenance
Mode
Battery life ended
User aborted Quick Initialization. Normal.
Progress in percent of synchronizing or rebuilding a
logical drive. Normal
Power switched OFF. Turn power ON.
Power is ON. Normal.
message appears frequently, note any malfunctions
and contact Technical Support.
Click on Enclosure1 in WebPAM to identify location of
overheat condition. Verify that there is ample space
around the enclosure. Check that all fans are running
and airflow is not obstructed. Correct any problems.
Click on Enclosure1 in WebPAM to identify failed fan.
Replace as needed.
management > Voltage in CLU.
Or click on Enclosure1 in WebPAM to check power
supply status. Replace as needed.
overheat condition. Correct any problems.
Normal.
Replace Battery.
Normal.
Could be a SEP problem. If this message appears
repeatedly, contact Technical Support.
Normal.
Replace Battery.
233
Chapter 8: Troubleshooting
Action