Indicator Light And Audio Signal; Checking Loose Strap Function; Checking Twin Speed Functionality - Invacare Robin Service Manual

Invacare® Robin™

5.2 Indicator light and audio signal

Hoist
Status Indicator light
Off / Stand by
Hoist traversing (Robin
Mover™only)
Hoist in use (Up/Down)
Low battery
The blue indicator light on the underside of the hoist turns off
automatically after 30 seconds.
Wall Mounted Charger
Status Indicator light
Battery not connected
Initializing and analysis
of battery
Fast charge
Charged (trickle
charge)
Fault condition (battery Alternating red
defect)
26
Audio signal
Off No
Blue No
Blue Flashing Yes
Duration
Yellow
n/a
Yellow 12–14 seconds
Red 5 min — 3 hours
Green n/a
n/a
and green

5.3 Checking Loose Strap Function

A correctly adjusted loose strap switch ensures that the straps stop
lowering when they touch an obstruction.
1. With the ceiling hoist remaining on the track, check there are
no obstructions under either strap hook.
2. Place an obstruction under one of the strap hooks, then press
and hold the down button on the hand control,
Expected result: When the strap hook touches the obstruction,
the strap stops lowering.
3. If the strap does NOT stop lowering, adjust the loose strap
switch. Refer to chapter 3.10 Adjusting Loose Strap Switch, page
16.
4. Repeat steps 2 and 3 for the second strap.

5.4 Checking Twin Speed Functionality

1. With the hoist on the track and both straps free from
obstructions, press and hold the up button with no load applied.
Note speed (40 mm/s) and sound of motor.
2. Whilst continuing to hold the up button, apply a load of at least
10 kg (e.g. by pulling down on both straps).
Note the speed reduction (30 mm/s) and motor sound change.
3. If there is no speed reduction, replace the twin speed switch.
Refer to chapter 3.11 Replacing the Twin Speed Switch, page 18.
1586747-A