Bobbin Winding With The - Husqvarna Viking Victoria User Manual

Bobbin winding with the machine threaded
tiOfl.
Note! Do not use a plastic presser foot when bobbin winding.
1. Place your empty bobbin with the small mark outwards on the bobbin spindle
on the front of the machine.
2. Pull the thread
from
the needle under the
presser
foot and to the right over the
thread guide (c).
3. Start from above and wind a few turns of thread around the bobbin. Cut off the
thread on the thread cutter (d).
4. I3ring the bobbin spindle clown. Press the foot control. When the bobbin
winding is finished, the bobbin will stop automatically. Remove the bobbin,
cut off the thread and bring the bobbin spindle up.
Note! We do not recommend v inding clear nylon or other stretchy threads
through the needle. Instead see 'Bobbin winding
-
ver&al
Spool 1fl".
Bobbin winding
-
vertical spool pin
1. Place an empty bobbin with the mark
outwards on the bobbin spindle on the
front of the machine.
2. Place the large spool holder under the thread on the spool pin.
3. Bring the thread under the thread guide (a) and mer thread guide (h), then
around thread guide (c) as illustrated.
4. From above wind a few turns of thread around the bobbin and into the
cutter.
5. Bring the bobbin spindle down, Press the foot control. When the bobbin
winding is finished, the bobbin will stop automatically. Remove the
bobbin, cut off the thread and bring the bobbin spindle up.
Make sure that the presser kx)t is up and the needle
is
in the highest posi
User's Guide Victoria
11