Advertisement
Red Bull Racing RB7: Step by Step
Clean the Lexan body with detergent and warm water, then dry it
thoroughly with a lint-free cloth.
The dotted red lines show all the areas on the outside of the body that you
should cover with masking film.
To mark off the nose, place the Lexan blank on the display body and draw
along the rear edge of the yellow area.
Cut several pieces of masking film and stick them to the outside
so that they cover all the openings in the bodywork (see the
always retain their perfect, high-gloss finish and are not
easily scratched.
Before you start painting, you must remove all particles
of dust and dirt from both the inside and the outside of the
body. Clean the body by rinsing it thoroughly with warm
(not hot) water, then apply a few drops of a degreasing
detergent to a cleaning cloth and use it to remove any
residual dirt and grease, especially from the inside. Finally,
rinse the body thoroughly with clean water and wipe it dry
with a clean lint-free cloth.
In the area behind the cockpit, draw the outline of the upper
489
photograph below left).
air intake with a marker pen, as shown.
™
Advertisement
