Advertisement
Red Bull Racing RB7: Step by Step
05
As you did with the front of the
body in Step 02, use the reamer
to make five holes around the cockpit
using the dotted red circles as a guide.
Each hole should be 1mm in diameter.
08
Very carefully, use your Lexan
shears to cut out the sections
marked by the dotted lines in Step 06.
Don't cut all the way to the edges with
the shears, but instead leave a millimetre
or so and then use fine-grade sandpaper
or a fine file to work the edges to a
smooth curve, matching the dotted
lines exactly.
06
Next, cut two larger holes in
the front face of the induction
pod section of the running body – the
locations of these are shown by the
dotted red lines.
09
Next, use the reamer to create five more small holes on the top of the body. The
two holes set close together at the front of the induction pod area should have a
diameter of 1mm, while the other three should be 5mm.
507
07
Place the reamer at the centre of
each section indicated in Step
06, and bore a hole large enough for one
blade of your Lexan shears to fit inside it.
™
Advertisement
