DeAGNOSTINI MODEL SPACE Red Bull Racing RB7 Build Manual page 14

Red Bull Racing RB7: Step by Step
15
Turn the model to its upright position, then slide the front wing assembly over the
front end of the chassis so that the screw holes at the rear of the wing line up with
those on the chassis (see arrows).
17
Tighten both screws fully with
the screwdriver.
18
Now lower the 3 x 18mm countersunk screw into the rear hole (see red arrow), and
tighten it fully.
497
16
When the holes line up exactly, as
shown above, insert the two 3 x
14mm countersunk screws supplied with
this stage into the indicated holes.
™