Advertisement
Red Bull Racing RB7: Step by Step
18
Position these two stickers on
each side of the raised fin on the
upper section of the right side of the
front wing.
21
Lay the running body front wing on your work surface, and position the left and
right front cascade wings as shown, above the corresponding sides of the front
wing. Lower these into position, as indicated by the long green arrows, then insert four of
the 2 x 6mm countersunk screws into the holes indicated by the short arrows.
19
Next, cut around the sticker
numbered 5. Note the small details
shown by the dotted line.
513
20
Place this sticker on the upper
portion of the wing, so that it
lines up with the top of the double letter
'l' of 'Bull' .
22
Tighten each screw with a
screwdriver to secure the two
cascade wings to the front wing.
™
Advertisement
