Advertisement
Red Bull Racing RB7: Step by Step
01
First, remove the top camera
from the sprue and place the
part on a cutting mat. Then, using a
knife, carefully remove any burrs left on
the edges.
04
Lay the decal sheet supplied
with Stage 92 on your cutting
mat and carefully cut around the red
decals numbered 2-6, marked here by
the dotted green lines.
02
Remove any dirt or grease from
the camera using a damp cloth
with a little detergent, then allow to dry.
Once dry, apply a thin coat of a white
primer to ensure an even finish. Once the
primer is dry, spray a thin layer of gloss
black paint onto the part and allow to dry
for at least 15 minutes.
2
3
4
05
Submerge the decals in warm
water for a minute, then apply
them to the numbered areas outlined
here by the dotted red lines. Double-
check against the photo for Step 06
to make sure you fit the decals in their
correct positions.
500
03
The paint must form an opaque
layer, so if you can see the plastic
through it when it is dry, apply another
thin layer so that it looks like the one in
the photo. Make sure that the paint has
fully dried before continuing.
6
5
06
The top camera should now look
like this. Leave it to one side to
dry fully.
™
Advertisement
