Advertisement
Red Bull Racing RB7: Step by Step
25
Cut short lengths of masking
tape and cover the two pins at
the end of the part, as shown.
28
When the paint is dry, insert the
pitot tube, as shown, into the
shaped hole at the front of the display
body. To make subsequent assembly
stages easier, do not glue the part into
place at this stage.
26
Clean and prime the pitot tube,
then spray the part as you have
done previously, using the pearl blue
spray paint.
29
Finally, remove and de-burr the
antenna and paint it gloss black.
When dry, fit it into the small round hole
just ahead of the cockpit. Again, do not
glue the part in place just yet.
504
27
Wait for the paint to dry (again,
apply two coats if necessary),
then remove the tape. Spray some of the
silver spray paint at close range onto a
paint lid or other smooth, clean surface,
then dab a fine paintbrush into the pool
of paint that forms. Then use the brush
to carefully paint the two pins silver.
30
This session is complete, and
your RB7's display body is
nearing its completion. Store all your
parts away safely until next time.
™
Advertisement
