Advertisement
Red Bull Racing RB7: Step by Step
07
Dot the thin projection on the
top of the air induction pod
(indicated by the arrow) with a little
adhesive, then place the top camera
onto this, as shown.
10
When the paint has dried, press
the sensor into the rectangular
hole in the right side of the display
body, following the photo to get the
orientation correct. The lower part of the
sensor must sit within the hole. It is not
necessary to glue the part at this stage.
08
Next, remove the sensor from
the sprue, using a knife. De-burr
the part once it is separated.
11
Next, separate the head pad from
the sprue, and remove any burrs.
501
09
Clean the sensor the same way
as you cleaned the top camera
in Step 02, and when it is fully dry, spray
it with silver paint. Again, it is advised
to prime the part first, and if necessary,
to apply two coats for a smooth, fully
opaque finish. Allow the part to
dry completely before continuing.
12
Clean and prime the head
pad, then spray it semi-gloss
black, and leave it to dry fully before
continuing with the assembly.
™
Advertisement
