Advertisement
Red Bull Racing RB7: Step by Step
19
Again, if you find it difficult to fit
the screw into place, press down
on the pushrod mount a little.
22
Fully tighten all three screws.
20
Turn the model around again,
and insert the two 3 x 10mm
countersunk screws supplied with this
stage into the indicated holes.
23
This session is now complete, so store the display body and chassis away
safely until next time.
498
21
Insert another 3 x 8mm
countersunk screw into the
indicated hole and tighten it.
™
Advertisement
