Delete All Programming" Menu - Bodet Sigma C Installation And Operating Instructions Manual

11.7 "Delete all programming" menu

This menu can be used to delete all the programming.
To go to this master clock menu, validate the option in the
technician menu with the
The following screen is displayed :
To delete, validate with the
11.8 CPU software download menu
This menu allows you to update the program code in Flash.
In the www.bodet-time.com/en/support.html, click on "Downloads". Download the latest version
of the programs on your USB flash drive.
To go to this master clock menu, validate the option in the
technician menu with the
Follow these steps before proceeding to the firmware update:
1- The USB drive should contain only the update version of the firmware.
2- The USB flash drive should contain only the update version of the firmware.
3- Turn the power back on and proceed with the update.
4- The code file (*.cod) must be on the root of the USB flash drive and be the only ".cod" file.
Insert the USB key.
The following screen is displayed :
to download,
validate with the
The following screen is displayed :
validate with the
The Sigma may not restart if these steps are not followed and the CPU card will have to be
replaced.
A power failure during the update process will cause "System Failed" alarm. Again, the card
must be replaced.
key.
key.
key.
key.
key.
Delete programing ok
Update syst. soft
Delete all prog:Yes ú
C o n f i r m d e l e t e
a l l p r o g r a m s
Update syst. soft ok
Factory config.
Connect USB key then
press ok
Reading USB
in progress ......
Confirm syst. soft ok
update
Transferring
Stage 01 ......
õ
ok
ú
o k
õ
exit C
C
33