Viewing The Circuits - Bodet Sigma C Installation And Operating Instructions Manual

8.3 Viewing the circuits

1/ Select the number of the circuit you wish to view with the
2/ Select DISPLAY mode with the
3/ Validate with the key
The display of the parameters is fixed and the step
numbers flash.
The and
Use the key to exit from the menu at any time.
The program steps are displayed in the order of the times and then by type: weekly order,
holidays, special and then PC.
Steps 01 to 99 are indicated with the total number of steps; if the step is greater than 99 then
only the step number from 001 to 500 is displayed.
8.4 Programming the circuits
1/ Select the number of the circuit you wish to program, or modify the programming with the
key.
The circuits can be programmed in the following modes:
- Weekly,
- Holidays,
- Special,
- Public holidays,
- Additional step,
- Astronomical,
- Periodic.
Only the first 4 modes are accessible from the master clock. All the modes are accessible from
the PC software.
2/ Select PROG mode with the
If the first step is blank, the time flashes.
3/ Enter the time with the
validate with the
4/ Proceed in the same way for the minutes and then the seconds.
and
.
keys can be used to scroll through all the program steps.
and
and
key.
keys.
keys and validate with the
keys and then
key.
Cir.01:08:02:00 03s
MTWTFS- Weekly 01/12 ú
key.
Cir.01:HH:MM:SS ---
MTWTFS- Weekly 01/01 ok
ú
21