Using The Wireless Lan Board In A Network - Canon Wireless LAN Board-B2 User Manual

Status
Flashes five
times
If the Extension Card Settings Screen Can Be Displayed
Confirm the status of the LNK indicator, ERR1 indicator, and any error messages to
resolve the error.
3
LNK Indicator
Status
Not lit
Flashes
ERR1 Indicator
Status
Flashes once
Flashes twice
Flashes three
times
Flashes four
times
Flashes five
times
3-6
Network Connection and Printing Troubleshooting
Cause
The Wireless LAN Board is
communicating in the
emergency startup mode.
Cause
Hardware error.
Incorrect wireless LAN
settings.
Cause
Unsupported EAP type
received.
Invalid certificate.
Time not set.
Received invalid
authentication packet.
Authentication rejected by
authentication server.
Remedy
Update the firmware and start the correct
firmware. (See "Updating the Firmware,"
on p. 4-9.) If the Wireless LAN Board still
does not work after updating the firmware,
contact your local authorized Canon dealer.
Remedy
Contact your local authorized Canon dealer.
Refer to "Error Messages," on p. 3-7, and
Chapter 2, "Using the Wireless LAN Board
in a Network," to confirm whether the
wireless LAN settings are correct.
Remedy
Set the EAP type of the access point to the
EAP type set in "802.1X/EAP Settings,"
on p. 2-20.
Refer to "802.1X/EAP Settings," on p. 2-20,
and "WPA/WPA2-PSK Settings," on p. 2-27
to set a valid certificate.
Set the time. (See e-Manual > Settings/
Registration.)
Refer to "Error Messages," on p. 3-7, and
Chapter 2, "Using the Wireless LAN Board
in a Network," to confirm whether the
wireless LAN settings are correct.