Enabling The Settings - Canon Wireless LAN Board-B2 User Manual

Enabling the Settings

This section describes the procedure for enabling the settings of the Wireless LAN
Board using the control panel of the machine.
The changed settings are saved to the Wireless LAN Board after the consistency of
the following settings has been checked. If the settings are found to be inconsistent,
an error message is displayed. In this case, refer to "Troubleshooting for Specifying
and Saving Network Settings," on p. 3-2 to change the settings to their correct
values.
Encryption and
Authentication Method
802.1X/EAP+WEP
WPA/WPA2+802.1X/EAP
WPA/WPA2-PSK
WEP
1
Press [Save Parameter] on the Extension Card Settings
screen.
Content Checked
Checks whether a root CA
certificate and user name are set. If
[TLS (WLAN Card Certificate)] is
selected in [EAP Type], checks
whether a wireless LAN card
certificate and private key are set.
Checks whether PSK is set in
either
[PSK ASCII (8-63 characters)] or
[PSK Hex (64 digits)].
Checks whether a WEP key is set
in the index selected by pressing
[Select WEP Key].
Reference
802.1X/EAP Settings:
p. 2-20
WPA/WPA2-PSK Settings:
p. 2-27
WEP Settings: p. 2-28
Enabling the Settings
2
2-31