Glideboard: Roller Removal And Assembly - Total Gym ELEVATE Jump Owner's Manual

ELEVATE ® JUMP OWNER'S GUIDE
TM

GLIDEBOARD: ROLLER REMOVAL AND ASSEMBLY

STEP 1. Remove the six M6 screws from
both the Rail End Caps on the top end of
14
the rails with a 4 mm Hex Wrench (not
included) and remove the end caps.
STEP 2. Remove the gas strut brake by
unscrewing two screws below the top
placard panel with a 5mm Hex wrench
(Not included).
Screws
STEP 3. Roll the glideboard up and out
the top of the rails and set it upside down
on a clean smooth surface.
STEP 4. To remove the rollers use a 13
mm socket wrench and a 13 mm open-
end wrench. Insert socket wrench over
the bolt on the outside of the roller as
you engage the open-end wrench on the
nut on the inside of the frame; turn to
unscrew.
Bolt
Nut
NOTE: Socket wrench and open-end
wrench not included.
STEP 5. Replace the rollers as needed
and reinstall the bolt and nut. Tighten
just enough so that the wheel can roll but
does not slide lengthwise on the axle. DO
NOT OVER TIGHTEN.
STEP 6. To reinstall the glideboard by
carefully & slowly rolling it into the rails.
STEP 7. Replace the gas strut brake and
insure both screws are tight.
STEP 8. Replace the rail end caps on the
rails and insure all 6 screws are tight.