Figure - Toro TurfMaster 22205TE Operator's Manual

Setup
Important: Remove and discard the protective plastic
sheet that covers the engine and any other plastic or
wrapping on the machine.
1
Installing the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the 2 bolts from the machine frame in the
location shown in

Figure

1. Bolt (2)
2. Rotate the handle rearward to the operating position.
3. Secure the handle to the machine with the bolts that
you removed in step 1.
4. Tighten the fasteners that support the handle on both
sides of the machine as shown in
3.
2
1
SUPERCEDED
G028426
Figure 3
2. Nut on handle support
bracket (2)
Figure 4.
1. Install a cable tie here.
2. Nut on handle support
bracket (2)
5. Install a cable tie to secure the cables to the lower
handle in the location shown in
the excess material from the tie.
2
Adjusting the Handle Height
No Parts Required
Procedure
1. Stand in the operating position to determine the most
comfortable handle height.
2. Remove the handle bolt and insert it in 1 of the 3 holes
located at the bottom of the handle bracket
g028426
5
2
1
G028427
Figure 4
3. Bolt (4)
Figure 4 and trim off
3
g028427
(Figure 5).