Servicing The Blade-Drive System - Toro TurfMaster 22205TE Operator's Manual

4. Remove the fuel filter
loosening the tube clamps surrounding the fuel filter.
5. Install a new fuel filter in the fuel line using the tube
clamps that you removed in step 4.
Servicing the Blade-Drive
System
Service Interval: After the first 5 hours
Every 50 hours—Remove debris from under the belt
cover.
Every 50 hours—Service the blade-drive system.
1. Loosen the 2 screws on the belt-cover-access panel and
remove the panel (Figure
2
1
Figure 36
1. Belt-tension spring
2. Adjusting bolt
3. Gap
4. Adjusting nut
2. Brush or blow out debris from the inside of the belt
cover and around all the parts.
3. Hold a feeler gauge set between 0.005 and 0.03 inches
(0.13 and 0.76 mm) against the wall and slide it down
behind the belt tension spring; refer to
(Figure 35) from the fuel line by
36).
3
4
7
8
g019641
5. Blade-drive belt
6. Wall
7. Belt cover
8. Belt-cover-access panel
SUPERCEDED
Figure 37.
1. Read the Operator's
Manual before performing
any maintenance.
Note: If there is a visible gap between the gauge and
the spring, tighten the adjusting bolt and the nut until
the feeler gauge barely slides freely in and out of the
gap (Figure
Important: Do not overtighten the adjusting bolt.
This could damage the blade-drive belt.
4. Install the belt-cover-access panel.
5
6
g019641
21
Figure 37
2. Check belt tension every
50 hours.
36).
decal116-8528