Cleaning The Wheels - Toro TurfMaster 22205TE Operator's Manual

Figure 27
1. Right rear wheel
Note: The blades will draw in water and wash out
clippings. Let the water run until you no longer see
clippings being washed out from under the machine.
4. Shut off the engine and wait for all moving parts to
stop.
5. Turn off the water.
6. Start the machine and let it run for a few minutes to dry
out the moisture on the machine and its components.
Scraping under the Machine
If washing does not remove all debris from under the
machine, scrape it clean.
1. Disconnect the wire from the spark plug.
2. Drain the fuel from the fuel tank; refer to
the Fuel Tank and Cleaning the Filter (page
3. Tip the machine onto its side, with the air filter up in
the air, until the upper handle rests on the ground.
4. Remove the dirt and grass clippings with a hardwood
scraper; avoid burrs and sharp edges.
5. Turn the machine upright.
6. Fill the fuel tank.
7. Connect the wire to the spark plug.

Cleaning the Wheels

Service Interval: Every 40 hours
1. Remove the rear wheels and clean any debris from the
wheel-gear area.
g002275
Emptying
20).
SUPERCEDED
1. Gears
2. After cleaning, apply a small amount of anti-seize to
the gears.
Note: If you are operating the machine in extreme
conditions, cleaning the wheels more frequently than
recommended will result in increased gear life.
Note: To prevent damage to the bearing seals, do not use a
high pressure water sprayer on the bearings.
16
Figure 28
g196471