Toro TurfMaster 22205TE Operator's Manual page 26

Note: Save the bolts for installing the belt cover to
the machine housing.
4. Remove any debris from under the belt cover.
5. Loosen the cable-clamp screw
Figure 47
1. Cable-clamp screw
6. Pull the cable jacket to remove slack
Note: Do not put tension on the spring.
Figure 48
1. Cable clamp
7. Mark the brake cable
until there is approximately 3 mm (1/8 inch) of slack
(Figure 50).
(Figure 47).
2
1
G019923
2. Blade-brake cable
(Figure 48).
SUPERCEDED
2. Spring
(Figure 49), then adjust the jacket
1. Mark the cable here
g019923
1. Slack—3 mm (1/8 inch)
8. Torque the cable-clamp screw to 11 to 14 N∙m (99 to
121 in-lb) to lock the adjustment in place.
9. Install the belt cover with the 4 bolts that you removed
in step 3.
10. Connect the wire to the spark plug.
11. Check the operation of the blade-brake clutch.
Changing the Transmission
g195540
Belt
Service Interval: Every 250 hours
1. Shut off the engine and wait for all moving parts to
stop.
2. Disconnect the wire from the spark plug.
3. Remove the 4 bolts that hold the belt cover to the
machine housing.
Note: Save the bolts for installing the belt cover to
the machine housing.
4. Remove the belt cover.
5. Remove any debris from under the belt cover.
26
Figure 49
Figure 50
g195615
g195616