Bagging The Clippings - Toro TurfMaster 22205TE Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
If the side-discharge chute is on the machine, remove it and
install the side-discharge door before bagging the clippings;
refer to Removing the Side-Discharge Chute (page
Installing the Grass Bag
1. Raise and hold up the rear door
2
G019798
Figure 24
1. Bag rod
2. Remove the rear-discharge plug by pulling down on the
latch with your thumb and pulling the plug out from
the machine (Figure
3. Install the bag rod into the notches at the base of the
handle, and rock the bag back and forth to ensure that
the rod is seated at the bottom of both notches; refer
to Figure 24.
4. Lower the rear door until it rests on the grass bag.
Removing the Grass Bag
To remove the bag, reverse the steps in
Bag (page 14).
Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
15).
(Figure 24).
2. Rear door
23).
SUPERCEDED
Installing the Grass
Installing the Side-Discharge Chute
Important: Ensure that the rear-discharge plug is in
place before you recycle the clippings.
1. Shut off the engine and wait for all moving parts to
stop.
2. Remove the grass bag if it is installed on the machine;
refer to
3. Insert the rear-discharge plug; refer to
Clippings (page
4. Remove the side-discharge door by pulling up on the
spring that holds the door in place and removing the
door (Figure
1
g019798
1. Top of side-discharge door 3. Side-discharge door
2. Spring
5. Install the side-discharge chute
up on the spring, placing the chute over the opening,
and lowering the spring over the taps on the top of
the discharge chute.
1. Side-discharge chute
14
Removing the Grass Bag (page
14).
25).
1
2
G019649
Figure 25
(Figure
1
Figure 26
14).
Bagging the
3
g019649
26) by pulling
g019647
g019647