Changing The Blade-Drive Belt - Toro TurfMaster 22205TE Operator's Manual

Important: Position the curved ends of the blades
to point toward the machine housing. Be sure to
nest the raised areas on each blade driver with the
recesses in the head of its corresponding spindle,
and the pins on the other side of each blade driver
with the holes in its corresponding blade.
2. Steady each blade with a board and turn the blade bolt
clockwise with a torque wrench as shown in
torque each blade bolt to 82 N∙m (60 ft-lb).
Figure 42
Important: A bolt torqued to 82 N∙m (60 ft-lb) is
very tight. Put your weight behind the wrench and
tighten the bolt securely. This bolt is very difficult
to overtighten.
3. Rotate the installed blade 1/4 turn until it is vertical,
and install the other blade in the same manner as the
first (refer to step 1).
Note: The blades should be perpendicular, forming
an inverted "T" as shown in
1
Figure 43
1. Blade (2)
Figure 42;
g016537
g016537
SUPERCEDED
Figure 43.
G016536
g016536
4. Tighten the second blade; refer to step 2.
5. Rotate the blades by hand a full 360° turn to ensure
that they do not touch.
Note: If the blades touch each other, they are not
mounted correctly. Repeat steps
blades no longer touch each other.

Changing the Blade-Drive Belt

Change the blade-drive belt as needed.
1. Shut off the engine and wait for all moving parts to
stop.
2. Disconnect the wire from the spark plug.
3. Remove the belt cover
bolts that hold it to the machine housing.
Note: Save the bolts for installing the belt cover to
the machine housing.
4. Remove any debris from under the belt cover.
5. Remove the BBC belt guard and the mounting
hardware.
Note: Save the BBC belt guard and hardware for
installation later.
1. BBC belt
6. Remove the BBC belt from the front, left pulley.
7. Loosen the adjusting bolt
8. Remove the fixed idler pulley and the hardware
45).
Note: Save the idler pulley and hardware for
installation later.
24
1 through 3
(Figure 9) by removing the 4
G019899
Figure 44
2. BBC belt guard
(Figure 36).
until the
1
2
g019899
(Figure