Removing The Blades - Toro TurfMaster 22205TE Operator's Manual

1
1. Front of cutting deck
2. Measure at locations A
and B
2. Measure from a level surface to the cutting edges
at locations A and B,
dimensions.
3. Rotate the blades so that their opposite ends are at
locations A and B.
4. Repeat the measurements in step
Note: If the difference between the dimensions A and
B obtained in steps
the blades; refer to
WARNING
A blade that is bent or damaged could break
apart and could seriously injure or kill you or
bystanders.
• Always replace a bent or damaged blade
with a new blade.
• Never file or create sharp notches in the
edges or surfaces of a blade.

Removing the Blades

Replace the blades when they strike a solid object, are out of
balance, bent, or worn. Use only genuine Toro replacement
blades.
1. Use a block of wood to hold each blade steady and turn
the blade bolt counterclockwise as shown in
2
B
B
g016532
3
Figure 39
3. Measure form the cutting
edge to a smooth, level
surface
(Figure 39), and record both
2 and record them.
2 and 4 exceeds 1/8 inch, replace
Removing the Blades (page
SUPERCEDED
g016532
2. Remove each blade as shown in
23).
1. Spindle (2)
2. Blade driver (2)
3. Inspect the pins on the blade drivers for wear and
damage.
Installing the Blades
WARNING
Incorrectly installing the blades could damage the
machine or cause an injury to the operator or to
bystanders.
Install the blades according to the instructions.
Figure 40.
1. Install the first blade so that it is horizontal, along with
all mounting hardware as shown in
Note: Tighten the bolt with your fingers.
23
Figure 40
Figure 41.
1
G016530
4
Figure 41
3. Blade (2)
4. Blade bolt (2)
Figure
g016527
2
3
g016530
41.