Changing The Engine Oil - Toro TurfMaster 22205TE Operator's Manual

Figure 29
1. Cover
2. Foam pre-filter and paper
filter
4. Remove the foam pre-filter from the paper filter
29), and replace the paper filter if it is excessively dirty.
Important: Do not try to clean a paper filter.
5. Wash the foam pre-cleaner with a mild detergent and
water, then blot it dry.
Note: Do not add oil to the foam pre-cleaner.
6. Install the foam pre-cleaner onto the paper filter.
7. Install the air-filter assembly.
8. Install the cover.
3. Air-filter base
(Figure
SUPERCEDED

Changing the Engine Oil

Service Interval: After the first 5 hours—Change the engine
Every 50 hours—Change the engine oil (more often
in dusty conditions).
Note: Run the engine a few minutes before changing the
oil to warm it. Warm oil flows better and carries more
contaminants.
Engine oil capacity: With oil filter: 0.85 L (29 oz); without
oil filter: 0.65 L (22 oz)
Oil viscosity: SAE 30 or SAE 10W-30 detergent oil
API service classification: SJ or higher
1. Move the machine to a level surface.
g006591
2. Refer to Maintenance (page
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
4. Tip the machine onto its side (so that the air filter is up)
to drain the used oil from the oil-fill tube
18
oil without the oil filter.
17).
(Figure
Figure 30
3. Low
30).
g194742
(Figure 31).