Checking The Engine-Oil Level - Toro TurfMaster 22205TE Operator's Manual

Checking the Engine-Oil Level

Service Interval: Before each use or daily
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, then remove
the dipstick.
5. Read the oil level on the dipstick
•
If the oil is below the Add mark on the dipstick,
carefully pour a small amount of oil into the oil-fill
tube, wait 3 minutes, and then repeat steps
through 5 until the oil level is at the Full mark on
the dipstick.
•
If the oil is above the Full mark on the dipstick,
drain the excess oil until the oil level is at the Full
mark on the dipstick. To drain the excess oil, refer
to Changing the Engine Oil (page
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick into the oil-fill tube securely.
(Figure 14).
Figure 14
3. Low
(Figure 14).
SUPERCEDED
18).
Adjusting the Cutting Height
The cutting heights range from 38 mm (1-1/2 inches) to 127
mm (5 inches) in 13 mm (1/2 inch) increments.
View from front, left side of the machine
1. 38 mm (1-1/2 inches)
2. 51 mm (2 inches)
g194742
3. 64 mm (2-1/2 inches)
4. 76 mm (3 inches)
The cutting height is controlled with a front lever and a rear
lever, both on the left side of the machine
Figure 17). To raise or lower the machine, engage the lever,
raise or lower the machine, and then disengage the lever.
3
1
1. Squeeze the lever to disengage it.
10
6 7 8
5
4
3
2
1
Figure 15
5. 89 mm (3-1/2 inches)
6. 102 mm (4 inches)
7. 114 mm (4-1/2 inches)
8. 127 mm (5 inches)
Figure 16
Front cutting-height lever
G01991 1
g019911
(Figure 16 and
g019653
g019653