Table of Contents
Advertisement
6.7.4
Selecting the startup logo
When the projector is starting up, the manufacturer logo is displayed in the entire image. Setting the logo to
BLACK will disable the manufacturers default logo. Go to menu entry SETTINGS > SPLASH to change this setting.
6.8 Picture by Picture (PbP)
You may choose to view two sources simultaneously as a picture by picture.
The PbP-function allows viewing of two images side by side or on top of each other.
Certain restrictions apply to how sources combine when using PbP.
To view PbP:
•
Enter the INSTALLATION menu and activate the PICTURE BY PICTURE function
•
Move down to PICTURE BY PICTURE SETUP
•
Set up by selecting the sources you want under SOURCE 1 & SOURCE 2
•
The following special options are available for Picture by Picture-usage:
960x1080@60 Hz/120 Hz, 960x1200@60 Hz/120 Hz, 1280x1600@60 Hz/120 Hz,
depending on projector model, see 5.7.1 Installation > EDID sub menu
6.9 PIN code
The projector can be locked by a PIN (Personal Identification Number) code to control
access. The PIN code is 4 digits, and if the PIN code is activated, you must enter the
correct code to unlock the projector. Factory set PIN (1234).
To activate, deactivate or change the PIN code, see the SETTINGS > PIN CODE sub menu.
If an incorrect PIN code is entered, you may try again two times. If you fail three times in a row, entering
a PUK (unlock) code is needed. The PUK code is supplied with the product.
If you also fail three times with the PUK code, the projector locks up permanently, and can only be un-
locked by a special service unlock code.
To access this code, you will need to contact your dealer or a service station. The service unlock code will be gen-
erated based on a secure, encrypted number that is produced by the projector itself. The projector will produce a
new number every time.
In order to unlock the projector via a dealer/service station, proof of ownership must be provided by the
customer.
6.10 Disabling the wireless remote control (IR) receivers
The projector has 2 IR receivers, one in the front and one at the rear.
These receivers can be individually disabled if necessary. Go to menu entry INSTALLATION > IR FRONT / IR REAR
to disable the receivers.
54
Hide quick links:
Advertisement
Table of Contents
