Installation Main Menu - Barco Orion 1080 Safety And Users Manual

5.7 Installation main menu

image orientation:
source scan:
IR front
IR rear
OSD enable:
test image:
sync termination VGA:
sync termination SYNC1:
sync termination SYNC2:
sync termination SYNC3:
DisplayPort 1 eq
DisplayPort 2 eq
picture by picture
picture by picture setup
EDID:
synchronization:
Rotate image in desktop front, desktop rear, ceiling front, ceiling rear.
Search all input connectors for an active signal or stay on one connector.
Enable or disable front IR-receiver.
Enable or disable rear IR-receiver.
Sets how the OSD messages should appear.
On: All OSD messages are shown.
Only warnings: Only critical OSD messages are shown.
Off: No OSD messages are shown. The OSD menu is still accessible by clicking menu
on either the remote or the keypad.
Displays internal test images for projector alignment and setup. Selected ratio display
is shown in the center of the test image (white fill).
4:3; 16:9; 16:10; 1.85:1; 2.35:1; 5:4;
Combined: fills the imaging device with a white image and marks out the all of the
above aspect ratios.
Enable sync termination to 75 Ω /2.2 kΩ
Enable sync termination to 75 Ω /2.2 kΩ
Enable sync termination to 75 Ω /2.2 kΩ
Enable sync termination to 75 Ω /2.2 kΩ
Choice between Normal, High, Low (enables receiving signals via longer cables/
with higher bit rate)
Choice between Normal, High, Low (enables receiving signals via longer cables/
with higher bit rate)
Show two sources side by side
Choose the two sources to be shown side by side
Sub menu for EDID, see chapter 5.7.1.
Sub menu for synchronization see chapter 5.7.2 .
38