Sharp QW-GD52I472X-EU User Manual page 23

CHAPTER -6: SWITCHING ON THE MACHINE AND SELECTING A
PROGRAMME
Buzzer sound set up
Setting up the buzzer.
1- Press the Power On/Off touch button".(1) (if it is in OFF position).
2- Press and hold the "Delay " (4) and "Half load " (6) touch buttons
for 3 seconds at the same time to set the volume level.
3- While pressing the "Delay " (4) and "Half load " (6) touch buttons,
the display shows a of count down from 3 to 1.
• The first time the volume is adjusted, at the end of 3 seconds, "S03" is shown on the display.
• If the volume has been adjusted before, at the end of 5 seconds the previously selected level
is shown on the display (from ''S00'' to ''S03'').
The volume level is increased or decreased using the ''delay'' and " half load''.
- To increase the buzzer volume.
1) Press the "half load " touch button (6).
2) The display (3) changes from "S00" to "S03.
- To decrease the buzzer volume
1) Press the "delay " touch button (4).
2) The display (3) changes from "S03" to "S00". "S00" means that all buzzers are off
4- To exit volume adjustment mode, switch off the machine.
The last volume level selected will be stored in memory.
Note: From level sound ''3'' to ''1'', loudness level is reduced by stages
depending on level sound.
8
1 2 3
7
4 5 6
EN-23