Embroidery Unit Center Position - Brother PE770 Service Manual

Adjustment
Repairing or adjusting the embroidery unit, check this adjustment.
[Adjustment standard]
The needle drops in the center of embroidery sheet hole.
[Adjustment procedure]
Checking the embroidery unit center position
1. Remove the presser foot.
2. Attach the embroidery unit to the machine. (Remove embroidery hoop.)
3. Turn on the power, and press the [OK] button on the screen (Move the carriage).
4. Put the embroidery sheet on the embroidery hoop.
5. Attach the embroidery hoop to the embroidery unit.
6. Turn the pulley by hand and check the needle drops in the center of the embroidery sheet hole.
In case the needle does not drop in the center of the embroidery sheet hole.
1. Select the test mode "2" (Embroidery Position Adjust mode).
2. Adjust the needle position by pressing the button on the screen for the needle to drop in the center of the
embroidery sheet hole.
3. After adjustment, turn the power off (adjusting value is memorised automatically)

Embroidery unit center position

4 - 21