Weidmuller IE-SW-PL09M-5GC-4GT Hardware Installation Manual page 8

RJ45 (10-pin) Console Port Pinouts
Pin Description
1 ------
2 DSR
3 RTS
4 ------
5 TxD
6 RxD
7 GND
8 CTS
9 DTR
10 ------
RJ45 (10-pin) to DB9 (F) Cable Wiring
Switch
10/100/1000BaseT(X) Ethernet Port
Connection
The 10/100/1000BaseT(X) ports located on the front panel are used to
connect to Ethernet-enabled devices. Most users will choose to configure
these ports for Auto MDI/MDI-X mode, in which case the port's pinouts are
adjusted automatically depending on the type of Ethernet cable used
(straight-through or cross-over), and the type of device (NIC-type or
HUB/Switch-type) connected to the port.
In what follows, we give pinouts for both MDI (NIC-type) ports and MDI-X
(HUB/Switch-type) ports. We also give cable wiring diagrams for
straight-through and cross-over Ethernet cables.
10/100Base T(x) RJ45 Pinouts
MDI Port Pinouts MDI-X Port Pinouts
Pin Signal Pin
1 Tx+
2 Tx-
3 Rx+
6 Rx-
8-pin RJ45
Signal
1 Rx+
2 Rx-
3 Tx+
6 Tx-
- 8 -