Table of Contents
Advertisement
Wiring the Redundant Power Inputs
The switch IE-SW-PL09M-5GC-4GT has two sets of power inputs - power
input 1 and power input 2 – located on the 6-pin terminal block connector on
the top panel of the device. See sketch below how to connect.
Wiring the Digital Inputs
The IE-SW-PL09M-5GC-4GT has two sets of digital inputs, DI 1 and DI 2.
Each DI consists of two contacts of the 6-pin terminal block connector on the
device's top panel, which are used for the two DC inputs. The top and front
views of one of the terminal block connectors are shown here.
Communication Connections
The Ethernet switch has 3 types of communication port:
1 RJ45 console port (RS-232 interface)
4 10/100/1000BaseTX Ethernet ports
5 combination 10/100/1000T(X)/1000BaseSFP ports
RS-232 Connection
The Switch has one RS-232 (10-pin RJ45) console port, located on the top
panel. Use either an RJ45-to-DB9 (see the cable following wiring diagrams)
to connect the console port to your PC's COM port. You may then use a
console terminal software, such as Windows Hyper Terminal, to access the
IE-SW-PL09M-5GC-4GT's serial console. (Baudrate: 115200 bps, no parity,
8 data bit, 1 stop bit)
STEP 1: Insert the negative/positive DC
wires into the V-/V+ terminals,
respectively.
STEP 2: To keep the DC wires from
pulling loose, use a small flat-blade
screwdriver to tighten the wire-clamp
screws on the front of the terminal block
connector.
STEP 3: Insert the plastic terminal block
connector prongs into the terminal block
receptor, which is located on the
device's top panel.
STEP 1: Insert the negative
(ground)/positive DI wires into the ┴/I1
terminals, respectively.
STEP 2: To keep the DI wires from
pulling loose, use a small flat-blade
screwdriver to tighten the wire-clamp
screws on the front of the terminal block
connector.
STEP 3: Insert the plastic terminal block
connector prongs into the terminal block
receptor, which is located on the
device's top panel.
- 7 -
Advertisement
Table of Contents
