Weidmuller IE-SW-PL09M-5GC-4GT Hardware Installation Manual page 10

Multi mode:
100BaseFX 0 to 5 km, 1300 nm (50/125μm, 800MHz*km)
0 to 4 km, 1300 nm (62.5/125μm, 500MHz*km)
Single mode:
100BaseFX 0 to 40 km, 1310 nm (9/125μm, 3.5 PS/(nm*km))
The concept behind the LC port and cable is quite straightforward. Suppose
you are connecting devices I and II. Unlike electrical signals, optical signals do
not require a circuit in order to transmit data. Consequently, one of the optical
lines is used to transmit data from device I to device II, and the other optical
line is used to transmit data from device II to device I, for full-duplex
transmission.
Remember to connect the Tx (transmit) port of device I to the Rx (receive)
port of device II, and the Rx (receive) port of device I to the Tx (transmit)
port of device II.
LC-Port Pinouts
ATTENTION
This is a Class 1 Laser/LED product. To avoid causing serious
damage to your eyes, do not stare directly into the Laser Beam.
Turbo Ring DIP Switch Settings
The IE-SW-PL09M-5GC-4GT is a plug-and-play managed redundant Ethernet
switch. The proprietary Turbo Ring protocol was developed by Weidmüller to
provide better network reliability and faster recovery time. Weidmüller Turbo
Ring's recovery time is less than 300 ms (Turbo Ring) or 20 ms (Turbo Ring
V2) —compared to a 3- to 5-minute recovery time for commercial
switches—decreasing the possible loss caused by network failures in an
industrial setting.
There are 4 Hardware DIP Switches for Turbo Ring on the top panel of
IE-SW-PL09M-5GC-4GT that can help setup the Turbo Ring easily within
seconds. If you do not want to use a hardware DIP switch to setup the Turbo
Ring, you can use a web browser, telnet, or console to disable this function.
NOTE
Please refer to the Turbo Ring DIP Switch section and Using
Communication Redundancy section in the User's Manual for
more detail information about the settings and usage of Turbo Ring
and Turbo Ring V2.
- 10 -