Table of Contents
Advertisement
Using PC Cards
To install a PC Card:
1. Hold the card with its orientation symbol pointing into the slot and the top side of the card facing up.
The latch needs to be in the "in" position before you insert the card.
2. Slide the card into the slot until the card is completely seated in its connector.
If you encounter too much resistance, do not force the card. Check the card orientation and try again.
The computer recognizes most PC Cards and automatically loads the appropriate device driver. If the
configuration program tells you to load the manufacturer's drivers, use the floppy disk or CD that came with
the PC Card.
Removing a PC Card
NOTICE:
Before you remove a PC Card from the computer, click the
a card and stop it from functioning. If you do not stop the card in the configuration utility, you could
lose data. Do not attempt to eject a card by pulling its cable, if one is attached.
1. Press the eject button.
file://C:\Documents%20and%20Settings\rpaxman\Local%20Settings\Temp\~hh5972.htm
Page 2 of 3
icon on the taskbar to select
9/19/2003
Advertisement
Table of Contents
