Reattaching The Rower Belt - First Degree Fitness AQUA AR User Manual

Reattaching the Rower Belt

STEP 1
Velcro Facing Upward
STEP 2
Idle Wheel
STEP 3
Rower Handle
Belt/Bungee Pulley
STEP 4
Bungee Pulley
Bungee Shock Cord
STEP 5
Recoil tension will decrease over time as the Bungee Shock Cord
stretches. To increase recoil tension, simply push the Inner Clip
out of the Bungee Hook from behind, pull the required amount of
bungee through the Inner Clip and replace the Inner Clip into the
Bungee Hook as shown below.
Begin reattaching the Rower Belt by threading
around the Rower Belt Pulley with the Velcro side
facing upward as illustrated.
Next, thread the Belt around the Idle Wheel as
shown. Once around the Idle Wheel, attach the
Rower Belt to the Belt/Bungee Pulley. There is
an obvious "lip" at the attachment point.
Wind the Rower Belt onto the Belt/Bungee Pulley
until the Rower Handle is as it's furthest forward
position.
Rethread the Bungee Shock Cord (on opposite
side of the Idle Wheel) back through the Bungee
Pulleys and tie off at the Attachment Point.
Hint:
Before reattaching the Inner Clip/
Bungee Hook, tie a slip knot under slight
tension at the lower bungee pulley. This
will keep the bungee under tension while
reassembling the Bungee Hook.
18
Inner Clip
Bungee Hook