Label Position On The Product - Avery Dennison ALS 204 Operating Instructions Manual

C
ONTENTS
4.2 C
ONFIGURATION AND MONITORING

Label position on the product

Prerequisites:
– The label length must be specified.
– The label stop position must be set.
Configuration in dispensing mode:
Use the two right buttons to set the start offset (see
"Online settings" on page 22).
Or use the function menu settings:
LABEL SETUP > Start Offset
Call the
start offset.
– The label should be flush with the front edge of the
product:
Enter the distance between the product sensor and
the dispensing edge [47A].
– The label should be stuck at a distance from the
front edge of the product:
Increase the start offset by the distance [48A] to the
product's front edge.
function and set the
43
[47] Distance between the product sensor (left) and the
dispensing edge (right).
[48] Distance (A) between the label and the product's front
ALS
20x
256
GB
A
A