Assembly - ProForm 831.23744.1 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys and your own Phillips screwdriver
wrench , and rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the parts bag, check to see if it has been preassembled. If a part is missing,
call 1-888-533-1333.
M6 Nylon
Locknut (77)–4
M4 x 16mm M4 x 16mm
Screw (84)–14 Flat Head
Screw (94)–4
M10 x 20mm Button
Screw (79)–4
.
M6 Washer
(118)–4
M4 x 32mm Screw
(95)–2
M10 x 35mm Shoulder
Screw (63)–2
Wave Washer
(88)–6
M6 x 16mm Button
Screw (80)–6
M10 x 70mm Button Screw (75)–6
5
, adjustable
M10 Split
Washer (78)–10
M6 x 38mm Button
Bolt (76)–4