The General Assembly - Hobby King Arcus F3A Instruction Manual

The general assembly

Install the landing gears
1. When installing the landing gear, make sure to
insert the steering arm into the socket on the bottom
of the rudder. Then secure the gear assembly using
.
two wood screws
2. To install the main landing gear onto the fuselage,
fit it into the gear mounting saddle with the wheel
pants facing towards the nose of the plane and secure
it using four wood screws
PA 2.3X10MM(4)
Install the horizontal stabilizer
1. Snap the horizontal stabilizer into place by inserting
the right stabilizer half into the mounting slot first.
Make sure to slide it all the way to the front and
bottom of the slot .
PA 2.3X10MM(2)
.
2. Snap the left stabilizer half into place and make sure
that the elevator connector is properly in place on both
halves before fully inserting the stabilizer into place
Install the wings
1. To install the aileron control rods, insert the Z-bend
of the respective rod into the outermost hole of the servo
horn and secure the rod using the provided clip. Then
attach the other side of the rod to the swivel ball on the
control surface horn
7
.
.