Charge The Battery Packs - Hobby King Arcus F3A Instruction Manual

CHARGE THE BATTERY PACKS

Before you begin assembling your Hobbyking Arcus,
thoroughly read the instruction manual included with the
battery charger. Also familiarize yourself with the following
lithium polymer battery cautions. When satisf ed with your
understanding of the battery charge process and safe
handling of LiPo batteries, charge your f ight battery so it will
be ready to use when your assembly is complete.
LITHIUM BATTERY HANDLING AND USAGE
WARNING!! Read the entire instruction sheet included
with your battery charger. Failure to follow all instructions
could cause permanent damage to the battery and its
surroundings, and cause bodily harm!
 O NLY use a Li-Po approved charger. NEVER use a
NiCd/NiMH peak charger!
 NEVER charge in excess of 4.20V per cell.
 O NLY charge through the "charge" lead. NEVER charge
through the "discharge" lead.
 NEVER charge at currents greater than 1C.
 ALWAYS set charger's output volts to match battery volts.
 ALWAYS charge in a fi reproof location.
 NEVER trickle charge.
 N EVER allow the battery temperature to exceed 150° F
(65° C).
 N EVER disassemble or modify pack wiring in any way
or puncture cells.
 NEVER discharge below 3.0V per cell.
 N EVER place on combustible materials or leave
unattended during charge or discharge.
 ALWAYS KEEP OUT OF REACH OF CHILDREN.
ASSEMBLE THE MODEL
The general maintenance
Note: Before using CA or Epoxy glue, please test fit the
parts before applying the glue to make sure the parts fit
properly together.
The fuselage assembly
1. Equip the left fuselage half with the parts as shown in
the picture and glue both fuselage halves together
2. Attach the tail wheel to the rear landing gear assembly
as shown in the picture and install the rear landing gear
to the fuselage using two screws
3
.
.