Advertisement
Quick Links
EP P－ P51D
EP P－ P51D
EP P－ P51D
INSTRUCTIONS
Features:
Epp-P51D is epp fun fighters for outdoor flying.
Profile-scale high performance.Model is produced
by modern technology on CNC machines from EPP
"almost unbreakable" material. The flying time of
P51D is between 8 to 15 minutes, it depends on the
flying figures. It is very easy to land with the model ,
you are able to do it into your hand if you want like
with hand launch glider.
Before operating this unit, please read these instructions completely.
ALMOST UNBREAKABLE
Product Specifications:
Fuselage length: 680mm (26.8in.)
Wingspan: 840mm (33.0in.)
Flying Weight:320-350g (with battery)
Motor: 2208 KV 1450
ESC: 20Amp
Propeller: GWS 8040
Servo: 8g micro servo * 3pcs
Radio: 4/more channels
Battery: 11.1V 600-1000mAh Li-po 20C
Advertisement
Related Manuals for Hobby King EPP-P51D
Summary of Contents for Hobby King EPP-P51D
- Page 1 EP P－ P51D INSTRUCTIONS Product Specifications: Features: Fuselage length: 680mm (26.8in.) Epp-P51D is epp fun fighters for outdoor flying. Wingspan: 840mm (33.0in.) Profile-scale high performance.Model is produced by modern technology on CNC machines from EPP Flying Weight:320-350g (with battery) “almost unbreakable” material. The flying time of...
- Page 2 ALMOST UNBREAKABLE Do not fly under the conditions below Wind strong enough to make the trees rustle A street with many trees or street lamps Close to high voltage electrical wires High Population density areas Cautions for flying front lawns and parks make excellent flying areas. Make sure you have permission to fly and follow safety guidelines set by local authorities.
- Page 3 Cut a a straight slot on the fuselage to 580mm by knife as picture shown. The slot must be 3mm deep and ensure the 1.5mm carbon rod inset. Insert motor mount into the fuselage .use CA glue. press the wire into the slot． Screw motor into the motor mount , using 4pcs screws.
- Page 4 Using sharp knife cut the slot for the tube at left side of the fuselage Insert the servos into the hole as shown .use CA glue . .the slot must be 3mm deep .position slot as shown. 60mm Install the pushrod connector to the servo arm, insert the quick lock onto the pushrod connector .
- Page 5 15mm Insert the ailerons servo into the hole and put through the servo Using sharp knife cut an opening for ailerons servo .The opening cable into the opening for receiver .glue the servo using fusion must be 1mm smaller from each side. glue.
- Page 6 Put control surfaces into neutral Switch on the RC set. Put the control surfaces to the neutral as shown . Tighten the connector screws .cut the pushrods as shown . The horizontal stabilizer into the fuselage glue arround the edge with CA glue .check the perpendicularity as shown .
- Page 7 44mm Glue the wire into upper side of the wing using CA glue and activator Insert wings into the fuselage as shown . check if the wings is the spray . centre and in the right alignment .Also check if the wing is Use the same procedure glue the wire on the bottom side of the wing .
- Page 8 The accu pack press into the hole in fuselage . Fix the end of PVC without hole to the front of the canopy with glue. Install the canopy to the fuselage with screw and connector Final Check Check the model. It must be symmetrical and not twisted. Radio control set installation review top and side view, showing a basic radio installation.
Need help?
Do you have a question about the EPP-P51D and is the answer not in the manual?
Questions and answers