Prepare For Flight - Hobby King Arcus F3A Instruction Manual

The receiver and the battery department
1. Connect the servo cables and the ESC cable to the
receiver and secure the receiver with the Velcro tape.
Slide the battery into the battery bay as shown in the
picture .

PREPARE FOR FLIGHT

Check the control direction(Mode 2)
1. Before getting started, bind your receiver to your
transmitter. Please refers to your Transmitter Manual
for the operation procedures. Make sure all the control
sticks are in neutral position(Rudder, elevator and
ailerons) and the throttle in the OFF position. Turn on
the transmitter make sure all the trims and the sub trims
(For computerized TX) are in neutral position, and then
power on the ESC for the control system testing.
!!!Caution: To prevent personal injury, do not install
the propeller onto the motor shaft in the process to
bind your RX to your TX and to test all the control
channels until the manual tell you to do it.
2. Move the sticks on the transmitter to make sure all
of the surfaces are moving in right direction, please
refer the following pictures. If the control surfaces
deflect in the opposite directions , please reverse your
control directions according the guide of Tx's
instruction. And then make sure the servo arms are
moving proportional with the sticks to ensure the servo
functions well.
9
Aileron: Bank Left
Aileron: Bank Right
Rudder: Yaw Left
Rudder: Yaw Right
Elevator: Climb
Elevator: Descend