Hobby King Arcus F3A Instruction Manual page 7

The horizontal stabilizer and the elevator assembly
1. Insert the CF rod into the stabilizer joiner fully and
a small drip of CA is needed to fix the rod firmly in it.
2. Attach the swivel ball to the hole of the elevator
control horn as the picture shows.
3. Test fit and then attach both joining parts to the
Stabilizer using Epoxy .
The main landing gear assembly
1. Put together the wheel pants clips using CA. Secure
the gear axles with the nylon nuts provided and fit the
wheels into the wheel pants and the wheel pants to the
clips. Put the wheel assembly onto the axles, align the
wheel pants and secure them by using four wood screws
on each side on the inside of the strut. Put a washer on
each axle in between the pants and the wheel before
securing the wheels using the collars
6
.
The fitted assembly