Assembly - ProForm CardioCross Trainer PFEL2605.0 User Manual

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call toll-free 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver
mallet .
See the drawings below to identify the small parts needed for assembly. The number in parentheses below
each drawing is the key number of the part, from the PART LIST on page 14. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part
is not found in the parts bag, check to see if it has been preassembled.
M6 Washer
(55)–2
Console
Screw (68)–4
M8 x 5/8" Hex
Bolt (45)–6
M6 Arc
Washer (39)–4
M6 x 5/8" Pocket
Screw (46)–4
Locknut (56)–6
M8 x 3/4" Hex
Bolt (26)–2
M8 x 2 1/2" Hex
Bolt (40)–2
M8 x 3 1/2" Carriage Bolt (51)–2
, two adjustable wrenches
M8 Washer M8 Arc
(52)–4 Washer (54)–8
M6 Nylon M8 Nylon
Locknut (57)–4
M8 x 3 3/8" Hex Bolt (42)–2
4
, and a rubber
Wave Washer
(50)–2
M8 Cap Nut
(24)–2
M8 x 1 9/16" Hex Bolt (41)–4